Welcome, Guest. Please login or register.
Did you miss your activation email?

News:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - awellm1

Pages: [1]
1
'95.5-'04 Tacomas/'96-'02 4Runners (3rd Gen) / Re: uz questions
« on: April 11, 2009, 03:21:31 PM »
smitherz,

metalworking question-- would it be a good idea to use the aluminum 1UZ/R150 hybrid bellhousing to make a cast for a steel one? would this be too expensive? hard to source materials/people?

your a champion elaborator. go to work, friend.

2
Sourcing your UZ Engine and Compatibilty Issues / Re: parts drawings
« on: March 08, 2009, 11:23:12 PM »
I had a lot of questions on distancing with transmission adapters to a 1UZ so that the input shaft fits and i found this. its alot of cluttered information, but close to the bottom of the first post, where it says part III, theres a couple things about input shaft lengths. notably, the R151 input shaft and bellhousing is an inch shorter.

based on this, im thinking if you made an adapter for an R150, you could use the bellhousing from an R151 and make the adapter thick enough to make up the difference.

any feedback on whether or not im right would be awesome.

http://www.lextreme.com/forums/showthread.php?t=7112&highlight=series+transmission

3
Sourcing your UZ Engine and Compatibilty Issues / Re: parts drawings
« on: March 08, 2009, 10:52:17 PM »
in this thread they talk about the r-series tranmissions like they have the same bellhouse pattern. good enough confirmation for me.

http://www.lextreme.com/forums/showthread.php?t=7112&highlight=series+transmission

4
Sourcing your UZ Engine and Compatibilty Issues / Re: parts drawings
« on: March 08, 2009, 10:21:25 PM »
thanks alot man. this is exactly what i was looking for.

5
'95.5-'04 Tacomas/'96-'02 4Runners (3rd Gen) / Re: 1UZ-FE for my Taco
« on: March 05, 2009, 11:42:12 PM »
just a couple more things. how did you get the trans imput shaft to get into the hole for the pilot bearing? is there a place for a pilot bearing? elaborate, if you will, on all those distancing issues.

6
'95.5-'04 Tacomas/'96-'02 4Runners (3rd Gen) / Re: 1UZ-FE for my Taco
« on: March 05, 2009, 11:31:30 PM »
what flywheel did you use? im pretty sure you didnt say anywhere.

7
Sourcing your UZ Engine and Compatibilty Issues / parts drawings
« on: March 05, 2009, 10:36:15 PM »
does anybody know of a place where i could find detailed drawings of toyota parts with dimensions? Id like to draw up a bellhousing and flywheel to mate a 1UZ to an R150. I can have them made myself for a hell of alot cheaper than buying.

Pages: [1]