Notice: Trying to access array offset on value of type null in /home/customer/www/ on line 168

Deprecated: Function create_function() is deprecated in /home/customer/www/ on line 178
Show Posts - burnzya
Welcome, Guest. Please login or register.
Did you miss your activation email?


Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - burnzya

Pages: [1]
Mating an Automatic Tranmission / rubber isolator to u-joint
« on: December 27, 2009, 12:45:08 AM »
hey, i've read here that for the 4x4 you can simply replace the tailend of the lexus trans, with the toy trans so it mates to the transfer case.

my question is, since i'm using the truck for 2wd, can i use the tailshaft from an auto trans in a 3.0 auto 2wd pickup??

i have limitied room in my 73 hilux, and if possible i would like to use a u-joint over the rubber isolator.

thanks for any help you can offer!

'79-'83 Trucks (1st Gen) / Re: 73 hilux project
« on: December 15, 2009, 07:55:39 PM »
front cab mount

rear cab mount

'79-'83 Trucks (1st Gen) / 73 hilux project
« on: December 10, 2009, 01:57:08 PM »
hey guys i'm new here. i'm putting this here since there wasn't a forum for pre79 hilux's. my name's bernie, i'm from arizona.

my project is a 73 hilux 2wd, i picked it up off craigslist for $240 :) . factory it has an 18r-c, but the exhaust manifold was missing. after a couple months of half assed searching i decided a 1uz swap would be much more fun. the problem is the factory frame is way narrower than any 79-95 toyota truck. and since i'm installing air suspension onto it, i've decided to scratch build the entire frame and suspension, with the front suspension rough based off of the 84-95 2wd.

here is the truck

1uz donor from a 89 ls400

and after i pulled it and brought it home.

this is the begining of my scratch built frame

and this is what i have planned eventually, a bumper taillight combo from a 1975 cadillac deville

Pages: [1]